Common faults and warning signs
- Low differential pressure or flow alarms
- Pump noise, vibration or overheating
- Frequent seal leakage or loss of prime
- Uneven cooling at distant zones
All services
Water & pump systems
Pump Room Repair
Trace circulation and pressure problems across pumps, valves, controls and connected chilled-water equipment.
The equipment
How the system does its job.
A pump room moves chilled water through the cooling network and maintains the flow and pressure needed by chillers, coils and terminal units. Poor circulation can imitate a cooling fault, so pump performance, valve position, strainers, air in the system and control logic all need to be considered.
Diagnosis before decisions
Read the warning signs. Test the cause.
What we inspect or repair
- Pump rotation, current and mechanical condition
- Seals, bearings, couplings and alignment
- Valves, strainers and expansion arrangements
- Pressure sensors and variable-speed drives
- Visible pipework, insulation and leakage
A clear service process
From symptom to stable operation.
Measurements guide the repair scope. After the agreed work, operation is checked again against the original symptom.
- 01
Map
Review the circuit, duty/standby arrangement and affected zones.
- 02
Measure
Check pressure, flow indicators, motor current and vibration.
- 03
Repair
Complete the approved pump, valve, seal or control work.
- 04
Prove
Confirm circulation, changeover and stable system pressure.
Where it fits
Built around the real application.
- Chilled-water plants
- Commercial buildings
- Hotels and district systems
- Process cooling loops
Preventive maintenance guidance
- Exercise isolation valves and keep strainers clean.
- Trend pump current, pressure and vibration.
- Check duty/standby changeover and variable-speed control periodically.
Ready when you are
Tell us what the system is doing.
Share the equipment, symptoms and location. We’ll use that information to help define the next step.
Book pump rooms service